Details
Main Features:
● Work with Anet A8 3D printer heat bed
● Completely solve the issue that the power of hot bed is too large and the load current
● Under the premise of normal cooling, it works stable under I ( max ) = 25A, the current must not exceed 25A in working process
● General add-on heated bed power expansion module
● Note: the wire's color is random
Summary:
● Remove basically all outside screws for your Anet A8 control box
● Take pictures of existing board wiring
● Unscrew two large 12 / 14GA wires on the board labeled HOT BED
● Screw these two wires into the new MOSFET board labeled HOT BED
● Connect the small jumper wires ( white ) to the control board where you just remove the two wires and screw them down. Note the polarity on each board. Match ( + ) to ( + ) and ( - ) to ( - )
● Find 2 x 6 - 8 inches pieces of 12 or 14 AWG wire
● Run one of the 6 inches wires to the power supply ( + ), screw in. The other side to the ( + ) DC on the new MOSFET board. Repeat for the negative wire ( - ) to ( - )
● Many people use velcro to secure the new board to the top of the control box.
● Put everything back together
● When complete, you'll see a blue light activate for signal from inside the box when the bed heater is activated by the control board
Suitable for: Mainboard Control
Type: DIY Accessories
※ We ship to over 200 countries worldwide through fast and reliable delivery partners. You can choose your preferred shipping method on the Order Information page during the checkout process.
Total Delivery Time = Processing Time + Shipping Time
Processing Time:Before we ship your order, we have to prepare your products, perform strict quality-control tests and package items carefully.
Standard Shipping: 7-15 business days
Flat Rate Shipping: 10-30 business days
Other classification
